JCliff in a JBoss (EAP6) Domain Environment about jcliff HOT 3 OPEN

Domain mode is not supported yet. I can make the necessary changes, and
you can give it a try, but it'll take a few days.

On Wed, Dec 9, 2015 at 8:18 AM, naefhe [email protected] wrote:

In a running JBoss Domain environment (as opposed to a Standalone
environment), configuration changes and deployments are done on the one and
only Host Controller (HC) designated as the Domain Controller (DC). When
using the JBoss CLI to perform a configuration change on a specific host, I
have to talk to the DC and specify /host= in front of e. g. /subsystem=.
Similarly, to deploy content onto a particular group of servers, I have to
specify /server-group= in front of /deployment=, etc.

How can I tell JCliff to which HC (/host=) or to which Server Group
(/server-group=) to address a change or deployment, respectively? These two
nodes are currently not accepted by JCliff in Input files and I couldn't
find them in any rules either. Are there other mechanisms to achieve this?

Cheers,
Heinz

—
Reply to this email directly or view it on GitHub
#64.

from jcliff.

That sounds very good, thanks a lot!

from jcliff.

Added --pre= support. You can now add --pre=/host=someHost that will prepend /host=someHost to all commands. It should make it work for domain mode.

This will still need some puppet code changes, and I'll do those later, once we get this part working.

from jcliff.