Definition of M73 in t5uid1.py conflicts with display_status.py preventing use of Fluidd about klipper HOT 5 CLOSED

That's awesome, thank you! I am in the middle of a print this afternoon but will try to test the changes over the weekend. Sorry for putting this in the wrong repository by the way, I had my 6.5 year old climbing all over me...

from klipper.

I just pushed a change to the display_status branch that should allow my code to work alongside the display_status module.

I haven't had the time to test it just yet but you're more than welcome to try it.

from klipper.

Alright. Print finished and I swapped the Raspberry Pi, cloned the correct branch and restarted everything. Klipper now starts fine!

Fluidd (almost) works - a few things in the web interface are broken in it, but I believe this is likely related to a different (much more recent) Klipper version from your repo vs. what Fluidd expects. Basically Velocity, Acceleration & Accel to Decel all show 0 (zero) as values, and Extruder and Heater Bed Power both show NaN%. I should probably report it in the Fluidd repository.

One thing seems broken in your new code: the printer LCD no longer shows any changes in print progress, it's stuck at 0%. Progress does work on the Fluidd side. Everything else seems to be working just fine and the printer is doing another print using Fluidd & your new code. I'm even trying to push it a bit closer to the edge with ArcWelder GCODE.

Thank you again for all the hard work!

from klipper.

One thing seems broken in your new code: the printer LCD no longer shows any changes in print progress, it's stuck at 0%.

Keep in mind that the host needs to send M73 P commands for the progress to update.

It does appear to work for me and the configuration conflict is no longer an issue.

Edit: I merged these changes onto the master branch and I also merged the latest changes from upstream, which should help if you're trying to run Fluidd.

from klipper.

Of course! With all the back and forth I forgot that Octoprint needed a dedicated plugin for M73 P and Fluidd obviously does not do that by default. Thank you for all your efforts once again! This is awesome!

I just confirmed that it indeed works fine when I send M73 manually during print from Fluidd. I will close this issue, if that's ok. I am not sure what the GItHub custom is, should I be closing these as the originator or should you be closing these as the owner?

from klipper.