Cut down the cost of the PCB with panelization about flower HOT 5 CLOSED

@elysion check this comment - v3 is less than $5 fully assembled (except battery holder) delivered to your door - it hardly gets any cheaper. Maybe try using other fabrication service?

Otherwise this is still valid request, maybe someone is willing to do it anyway. Note, however, that sensing element should be of certain minimum size to be reliable, and you want RF part to be as away from the soil as possible. Interesting design would be separating the logic/RF/upper and sensing/lower part, each having pads to connect them with a e.g. ribbon cable. That would enable using different sizes of sensing elements (smaller or larger pots) or mounting RF part on the outside of the pod (not sticking up).

from flower.

Kindly do panelisation and submit gerbers in 0R

from flower.

@nurikk is it possible to publish original PCB design files or make EasyEDA project public? It is much harder to reverse engineer the gerber files and not much sense in reinventing the wheel. If the original project files would be available, I am sure someone (even me when I find some spare time) would be happy to do such improvements.

from flower.

@nurikk do you have any information on my question above, or shall I ask Jager on Telegram?

from flower.

Jager never shares sources, forget about it

from flower.