ERCF calibrate failing about enragedrabbitproject HOT 6 CLOSED

Make sure the klipper version on your MCUs matches the one on your rpi

from enragedrabbitproject.

I just checked there was a version mismatch so I have flashed everything to the newest version of klipper, but I am still getting the error. Currently this is my version:

from enragedrabbitproject.

Ok, thanks. Can you provide the klippy.log when this error occurs please?

from enragedrabbitproject.

So I cleared my log file and recreated the condition I happened to find this in the log at line 1820:
Heater extruder not heating at expected rate
Transition to shutdown state: Heater extruder not heating at expected rate
See the 'verify_heater' section in docs/Config_Reference.md
for the parameters that control this check.

klippy.log

from enragedrabbitproject.

Indeed, but the timer took close issue appears right at the call of the ERCF_HOME_EXTRUDER. I guess the issue comes from this function (located in the ercf.py). I don't know yet why it's happening to you

from enragedrabbitproject.

I found the issue was due to my own error in the extruder configuration my rotation distance was not set properly. I had upgraded all my firmware to a newer version prior to installing the ERCF. I did not do any prints without the ercf to verify my standalone configuration was properly working with the newest firmware. Once I revised the rotation distance this fixed the mcu time out issue.

from enragedrabbitproject.