How to make a pancake printer into an inkscape extension about plotink HOT 3 CLOSED

Yes, I saw your post over on the Inkscape forum.

This project, plotink, contains some helper routines for some specific pen plotters. So far as I know, none of the code that it uses or generates is compatible with the pancakebot.

It looks like the pancakebot uses gcode for control. You can already use the Inkscape g-code tools extensions to generate g-code that the pancakebot can run. This doesn't require any new software to be written for you.

from plotink.

Thank you very much for your answer ，Can you tell me where I can find the Gcode extension? I found an extension like this earlier, but when I opened it up it was an extension of the Pen Robot, and some of the instructions were different

from plotink.

No, this isn't something that we can help you with. However, the G code tools extensions that I was referring to are these: https://github.com/cnc-club/gcodetools

They are not the only ones out there. However, we do not use any of these tools, so we do not know much about them.

from plotink.