v2023.x: FUTRO running with x86-generic image does not run wgpeerselector after some boots about gluon HOT 2 OPEN

In FFAC we updated all x86-generic images with a x86-64 image, which worked well, as the hardware is generelly supported.
Though I would not recommend this step generally, as it will brick true i386 devices if there are any.
We did not seem to have any.

This issue will not be relevant anymore when v2023.1.x runs out of support (probably even if the v2023.1.x branch gets a kernel-bump again) and I don't mind closing it.

But if someone wants to keep this open, just reopen it.

from gluon.

I have just seen this issue also occur on a v2023.2.x firmware built bfbefa4 when testing..

This is not far behind v2023.2.x
bfbefa4...v2023.2.x

To reproduce - one should have a Futro with a gluon firmware from a community which uses wgpeerselector to connect meshvpn

1. run a sysupgrade - check if wgpeerselector works
2. run a reboot - check if wgpeerselector works

If both works fine, you are probably not affected, though you can not be too sure 🤷

from gluon.