Can’t work with EnigmaIOT about enigmaiot HOT 4 CLOSED

I have the same problem.
When I connect to the wifi for settings, It shows a wrong page and my esp8266 crashed and reboot.
Besides, the old version(0.9.7) can run correctly.

from enigmaiot.

I have ESP8266 (3.01) and ESP32 working but took me a long time to get this initial WiFi working, though mostly ESP32 issues.. Make sure you are using ESPAsyncWiFiManager -- https://github.com/gmag11/ESPAsyncWiFiManager forked from https://github.com/alanswx/ESPAsyncWiFiManager (and I edited this for ESP32)
ESP8266 - use "Generic ESP8266 Module" in Arduino IDE
Tools ->Erase Flash - erase ALL flash contents PLUS you have to jumper specific pins on ESP8266 as well (suspect this wasted a lot of my time, I was rebooting back to same code )
Minor: Avoid setting full debug on and setting speed to 115200
Have to say EnigmaIOT is working wonderfully, uptime/reliability is superb
Geoffrey Mills

from enigmaiot.

I finally found time to test "enigmaIOT" again, I installed version 0.97 and it works fine, it's a good job by Germán Martín.
Thanks for your support.

Carlos Leite

from enigmaiot.

I finally found time to test "enigmaIOT" again, I installed version 0.97 and it works fine, it's a good job by Germán Martín. Thanks for your support.

Carlos Leite

V0.97 does not seem to work with Hass. I bought some esp32 modules, and the gateway sketch works well with them.
In addition, I found that coding with PlatformIO is more efficient than using Arduino IDE.

from enigmaiot.