External power supply for Intel Realsense d415 about librealsense HOT 7 OPEN

Hi @tjak99 You can attach the camera to a mains electricity powered USB hub if your project is one where the camera does not need to move around, like on a mobile robot. Because a powered USB hub draws from the mains instead of the computer's power supply, camera connections are typically more stable than when the camera is plugged directly into the computer's USB port.

You can find examples of powered hubs on stores such as Amazon by searching for USB 3 powered hub. Hubs can have either a USB-A connector (full size) or USB-C connector (micro sized) so make sure to choose a USB-A hub as you are using a Jetson Nano.

Intel also have specific guidance about Nano, strongly suggesting to enable the barrel jack connector if your model of Nano board has one. Instructions for doing so can be found at the link below.

https://jetsonhacks.com/2019/04/10/jetson-nano-use-more-power/

from librealsense.

Thank you for the prompt response. The problem is that the camera is mounted on a mobile robot, so I cannot connect it to mains electricity. I considered a quick solution, but it seems I may need to design an external circuit for this application. If you have any more ideas, I would be grateful.

from librealsense.

The Nano has a micro-USB port that it can be powered by. I wonder if it would make a difference to the Nano's USB power stability if it was powered by a USB power bank. This is like a battery pack that you can charge up on mains power and then unplug and transport it, attaching a USB device to it to power it as though it was plugged into the mains.

There is an example of a discussion about powering a Nano with a power bank at the link below.

https://www.chiefdelphi.com/t/jetson-nano-power/379667

from librealsense.

Hi @tjak99 Do you require further assistance with this case, please? Thanks!

from librealsense.

I wanted to let you know that I managed to get it working. I used an external battery with a custom-made PCB and connected the output from the PCB to the Jetson header. This setup provides up to 6 Amps. Thanks for your rapid responses, great service

from librealsense.

You are very welcome. That's great to hear that you succeeded. Thanks very much for the update and for sharing the details of what worked for you!

from librealsense.

Hi @tjak99 After achieving a solution, do you require further assistance with this case please? Thanks!

from librealsense.