(feature request) width label to specify the width of output figure about jmax HOT 2 CLOSED

this is more of an org-mode issue. I don't think it makes sense to put it
in the caption. That would be difficult to parse, and #+ATTR_LaTeX: exists
for that. Maybe you can use yasnippets or abbrevs or write your own short
command to insert that text with the value you want.

John

John Kitchin
Associate Professor
Doherty Hall A207F
Department of Chemical Engineering
Carnegie Mellon University
Pittsburgh, PA 15213
412-268-7803
http://kitchingroup.cheme.cmu.edu

On Sun, Jun 22, 2014 at 11:38 PM, llcc [email protected] wrote:

Hi John,

Thanks for your org-ref.el and help before. According to your commands, I
can output figure properly with the below preamble. Because there are many
figures in my article, and i do not want to make them to same size (by
setting (setq org-latex-image-default-width ".7\textwidth") ), I use
:width to specify the output size of figure.

#+CAPTION: caption label:fig:cutting
#+ATTR_LaTeX: :width 0.9\textwidth

In my situation, I need to input the #+ATTR_LaTeX: :width 0.9\textwidth
so many times. So a idea comes: if :width can be put in behind of label,
like:

#+CAPTION: caption label:fig:cutting width:0.9

to accomplish the same function with #+ATTR_LaTeX: :width 0.9\textwidth,
it will save input time and even space.

I am not sure if you are interested with this idea, if yes, any help will
be appreciate!
Best regards.

—
Reply to this email directly or view it on GitHub
#20.

from jmax.

Hi John,

Thanks for your reply.
Actually I use Yasnippets to input various thing. I just think it will be more readable and less unnecessary contents in my article if #+attr_latex can be omitted. Now i know it is a tough work, and thank you anyway.

Best regards.

from jmax.