Memory clock keeps setting to +1000 and fan speed does not climb or drop about tuxclocker HOT 3 OPEN

Are you on the latest version on git?

from tuxclocker.

I'm seeing the same issue with the memory clocks. I'm not using the fan speed settings so no idea there.

This happens with both current git master and the last release 0.1.1. I think I know what's happening. You're storing the Memory Clock Offset in .config/tuxclocker.conf as the raw offset (2x what's shown on the slider). And when switching back to the card it loads this 2x version instead of the 1/2 raw offset. I tested by setting my offsets to 400 (instead of 650) and it reports 800 on switch back.

Let me know if you'd like me to test anything else out. This is on Debian with nvidia driver 460.32 and 4 GTX 1070's.

from tuxclocker.

Yeah i get this doubling too.

Does anyone know the nvidia-smi method to set the voltage offsets? This is the only too i can find to apply my +112 mv voltage offset to reach parity with my windows setup so i can carry my settings over?

Tried to also use the cli version of this but didnt get any life out of it

from tuxclocker.