[Bug]: Build Failure - two issues about firmware HOT 7 CLOSED

The wio-e5 environment is still a work-in-progress, see #2960.
Do you need specifically this environment? While this is set as the default_envs in platformio.ini, you can select the appropriate environment for your device.

from firmware.

from firmware.

For the wio-e5 environment or in general? The firmware should build successfully for all supported devices on the master branch as can be seen by the CI.
As I said, the wio-e5 is a work-in-progress in PR 2960 using branch stm32wl.

from firmware.

from firmware.

I’m confused then. I simply cloned the repo master branch, made no modifications, and attempted to build it. So I don’t see how your CI is successful when I can’t replicate a clean, unmodified build.On Jan 4, 2024, at 12:55 PM, GUVWAF @.> wrote: For the wio-e5 environment or in general? The firmware should build successfully for all supported devices on the master branch as can be seen by the CI. As I said, the wio-e5 is a work-in-progress in PR 2960 using branch stm32wl. —Reply to this email directly, view it on GitHub, or unsubscribe.You are receiving this because you authored the thread.Message ID: @.>

You need to pick your build target before building. That said, it's a problem if we're building a WIP target by default.

from firmware.

We've switched the default build target back to the T-beam. This should make the firmware build cleanly for that device, without setting the target, so closing this issue. Thanks for pointing out this unintended behavior!

from firmware.

from firmware.