[Bug]: ESP32-S3 Boards with Native USB Not Booting without USB Host Serial about firmware HOT 7 CLOSED

I've got the same behaviour for Lilygo T3S3 v1.2 for 3 devices I've flashed with 2.3.10 Beta just recently. Devices doesn't respond anyhow (power on/off, HW reboot etc) if NOT connected to PC.
I did device-update but not entire re-flash. Flashing (updating) back to FW v2,3,7 makes devices adequate back again.

from firmware.

I have the same problem on my lilygo t3s3 v1.3 via webflash (fullerase).
Device boots only when connected to PC. Any configuration change is ending in "Rebooting" and device starts only after disconn/conecting the usb.
FW 2.3.4 and 2.3.6 are working OK.

from firmware.

Updated the issue title to be more generic to ESP32-S3 with native USB

from firmware.

Please test these artifacts and see if it resolves the issue:
T3S3 - https://github.com/meshtastic/firmware/actions/runs/9418801324/artifacts/1579655956
EoRA S3 - https://github.com/meshtastic/firmware/actions/runs/9418801324/artifacts/1579647484

from firmware.

Hi, i was not able to install it on my T3S3, i tried only webflasher, but it was stuck on "stub running ... "
I have new PC so no python etc. instaled yet.
2.3.11 alfa works ok

from firmware.

2.3.11 alfa works ok

Wait, so it's already working in the latest alpha release of the firmware?

from firmware.

This is working fine in the latest 2.3.11 alpha. I just tested from full erase and install on a T3S3 and EoRA S3

from firmware.