Synchronize required cutouts in panels for XY mounts (front pulleys, motor mounts) about hevort HOT 6 CLOSED

Not quite there - but the basic idea would be to have a unified mount attached to the frame and custom cartridges for the different XY-Versions.

The mounting holes around the opening are for M4 heat inserts (this kind or similar: https://www.amazon.de/dp/B07YSV66Y5 ) to mount the cartridges.

Still very rough and without any fancy design elements ;)

from hevort.

Yes, that is a good point. I thought of this at one point and was teared between functionality and interchangeability. Perhaps an adapter plate of filler contour of some sort with provision holes in the smallest designs. Keep me posted on your proposal ;)

from hevort.

First idea for the footprint of the front pulley mounts would be something like this:

I'll try and trace the belt paths for the different variants tomorrow, maybe even a unified pulley mount with an adapter for the different belt paths would be possible :)

from hevort.

If i got the different belt paths correct a unified pulley mount should be possible:

Above and below the belts there is enough room for a secure mount :)

from hevort.

How about moving the Y Sensor bracket to the right pulley mount? That would simplify the wiring for the probe.

My prototype is still under development, at least the sketch on paper is taking form!

from hevort.

As we are looking at the next version of the HevORT, this is something that we will consider. But for now, there are no plan to modify existing release to harmonize their footprint on enclosure panel.

Thank you.

from hevort.