Question to guide 56. WIRED_IOT_LOCAL - Rule 1 (Allow DHCP) about ubiquiti HOT 6 CLOSED

I guess its a mistake, as you say it will work as you configured it.
A DHCP server uses port 67 and the client uses port 68.
There is no need to have port 68 as a destination, since there will never be a DHCP server amongst the IOT serving a LOCAL service.
You don't have to put port 68 in the source but it locks it down a bit more to do so as nothing should be talking to the DHCP server using any other port.

from ubiquiti.

Thanks guys, I'll look into this the next time I do a document update.

from ubiquiti.

Source should be port 68, Destination port 67

from ubiquiti.

OK, but why does it state destination {67-68}, and source empty? (It actually works with source empty at the moment, jut finished with the guide).

Thank you for your time :)

from ubiquiti.

Thanks for the explanation, I will correct the setup, so destination = port 67 and source = port 68.

Have a nice weekend :)

from ubiquiti.

Thanks Mike, I successfully setup up an ER-10X on firmware v. 2.0.6 and a UAP-nanoHD, with your guide.

from ubiquiti.