Large office shorter than multiplier would suggest about openstudio-standards HOT 3 CLOSED

Here is geometry for the large_office_reference.osm

large_office.osm and large_office_2010.osm seem to share the same geometry at first glance (at least height profiles for different spaces).

@asparke2 I can fix the mid and top floor positions to match large_office.osm without any problem. I did notice the basement height varies as well, I assume that was an intentional decision in support of the data center or for other reasons?. Charnged form 2.2394m to 2.4390m

from openstudio-standards.

Yeah it was probably for the data center addition

from openstudio-standards.

Here is fixed geometry. I cleaned up zone origins so they don't reference arbitrary z values. Then raised up the mid and top floors to match heights from the large_office_reference.osm file. Note that the mid floor is about 2 meters low of being centered, but I wanted to be consistent with the reference model. Left basement height as is. I deleted the large_office.osm file that didn't seem to be used.

from openstudio-standards.