Suggestions regarding build instructions, V3 about docs HOT 5 CLOSED

@sphawes @lucian151 can you comment on:

*** In Wiring, step 15: Cable is actually labeled LM, not LH (which is a tube).
*** In Wiring, step 17: Cable is actually labeled RM, not RH (which is a tube).

Is this correct? I will have to photoshop the images if so.

from docs.

@lucian151 @sphawes pinging you again to confirm the above

from docs.

RM/LM mean left motor or right motor, and plug into the left or right head. I can see why people are confused by this, so if the docs can be improved to address this fact it'd be easier than us updating cables to something else.

from docs.

Was about to open an issue but i see many of my notes already recorded here.
I also had wires labeled RM and LM in steps 15/17; had to remove and re-ziptie the clamp in 29/30 ; and was missing a M5-10 in step 34.

One addition: in step 31, it shows the LH and RH labels on the pneumatic fitting restraint with LH on top. My 3-d printed restraint had RH on top. The labels on the tube were far enough up the tubes that they were hidden under the control board. So basically, it's impossible to get anything looking like the picture :)

I'll create a separate issue for the issues with the openpnp instructions.

from docs.

*** In Wiring, step 15: Cable is actually labeled LM, not LH (which is a tube).
*** In Wiring, step 17: Cable is actually labeled RM, not RH (which is a tube).

Photoshopped, thanks for the heads up.

One addition: in step 31, it shows the LH and RH labels on the pneumatic fitting restraint with LH on top. My 3-d printed restraint had RH on top. The labels on the tube were far enough up the tubes that they were hidden under the control board. So basically, it's impossible to get anything looking like the picture :)

I think I already photoshopped the docs page so it should match real life, thanks.

from docs.