When excuting The term 'Select-MgProfile' is not recognized about 365inspect HOT 13 CLOSED

Here is what I executed using 7.3.5 version of powershell

from 365inspect.

Hi there!
Thank you for checking out our tool!
Please verify that you are able to connect to, and approve permissions for, Microsoft Graph PowerShell.
In your screenshot, your connection to Microsoft Graph failed (the line immediately before the error message about Select-MgProfile

When properly connected, you should see a message that you are connected via Graph to your tenant before connecting to the next module.

from 365inspect.

I agree on the connectivity to Graph when running it direct connect-graph & connect-mggraph It works without failure.

from 365inspect.

Could you try running the tool again?
In our testing, and the screenshot above, we ran it in PS version 7.3.5 and had no issues connecting.

from 365inspect.

Yes, I ran it several times and still received the same error. The service principal I am using is fully capable and has all the access. Not sure why it bombs out on the Microsoft Graph on the new version but the old version works fine.

from 365inspect.

Hi @kennyb7322
The authentication methods used in this tool are designed for an authenticated user, and currently does not support using a Service Principal or Application authentication context.

from 365inspect.

I could get it to work by using an older version of PowerShell, the beta version; I was getting the same results. I don't know if some authentication caused it not to execute properly. I am going to try it on different instances and report back.

from 365inspect.

What version of Microsoft.Graph PowerShell Module do you have installed?
This works currently, using user credentials, with version 1.19.0 and lower.

from 365inspect.

We can replicate this in version 2.0.0 of Microsoft Graph and are working on a resolution.

from 365inspect.

So it works on Powershell 1.9.6 Microsoft.Graph and lower you are correct it does not work in 2.0.0. and it does not work also on the release candidates.

from 365inspect.

So it works on my VM that I have running 1.9.6 that I configured with the older Graph versions, but when I try to push anything over 2.0.0 and RC, it does not work. My other question is it not necessarily an issue at all, but can I submit inspectors that would be helpful that I have created?

from 365inspect.

So it works on my VM but when I try to push it up to github I get an error. Any help will be greatly appreciated! Thanks.Manifest 1.9.6 Microsoft.Graph

from 365inspect.

Version 2.0.0 no longer supports the Select-MgProfile command.
In Microsoft's release notes for version 2.0.0 - https://github.com/microsoftgraph/msgraph-sdk-powershell/releases

We are working on a resolution to accommodate this change, in the meantime, you will need version 1.19.0 or lower to run the tool.

from 365inspect.