Can't connect about gcode-sender HOT 10 CLOSED

Hello,

If port is correct then close any other software, like UGS, that are using the port

from gcode-sender.

The port is not in use. I even rebooted. It looks like both your project and UGS use JSSC for serial, and UGS is working fine (the 7/23 nightly build anyway).

from gcode-sender.

Have you tried this ?

Note for MAC users: You may need to create a "/var/lock" directory with write permission. To do this open the Terminal application and run the following two commands:
sudo mkdir /var/lock
sudo chmod 777 /var/lock

from gcode-sender.

Yes, UGS has the same suggestion and as mentioned UGS is connecting fine.

OTWKLT0076:MacOS daryl$ ls -l /var
lrwxr-xr-x@ 1 root  wheel  11 Nov 12 21:48 /var -> private/var
OTWKLT0076:MacOS daryl$ ls -l /private/var | grep lock
drwxrwxrwx   17 root          _uucp          544 Nov 12 21:59 lock

from gcode-sender.

Do you have an official arduino with FTDI chip or a clone with the CH340 ?

from gcode-sender.

I have a Sanguino with a (version 1) USB-BUB from Modern Device. The chip has an FTDI logo on it.

from gcode-sender.

Hello,

Did you manage to connect ?

from gcode-sender.

Hi, no I didn't. I've committed to using Universal GCode Sender so I've not tried again.

from gcode-sender.

Really sorry to hear that and really sorry to bother you
Can you please tell me what baud rate you use with the UGS ?

from gcode-sender.

115200

from gcode-sender.