min_cycle_duration not working about ha-dual-smart-thermostat HOT 5 OPEN

Please let us know if v0.7.0 fixed it. Thanks @ollo69 !

from ha-dual-smart-thermostat.

Thanks a lot, @ollo69 but I have checked the min_cycle_duration is not working since v0.6.7. EDIT: It is working in v0.7.1

Asap the temp reaches the target, it stops without checking the min_cycle_duration configuration.

I have tested a bit more, it stops when low/high temperature changes, and then it calls _async_control_climate(force=True) which makes sense to force the stopping or starting of the device when the targets change.

Ok, I have to adapt my automations, but it is working. Thanks a lot again @ollo69

from ha-dual-smart-thermostat.

I second this same issue. I have noticed that the A/C will cut on and off every few seconds when close to set point. The biggest issue with this is that the A/C compressor can go out a lot quicker when being cut on and off so quickly and so much. What is the best fix for this?

from ha-dual-smart-thermostat.

This could be fixed by PR #37

from ha-dual-smart-thermostat.

"min_cycle_duration" is not working in the last release (0.9.1). It is constantly stopping my AC machines. I only see one "weird" log that says my cooler is "Already running". I see in logs that "keep_alive" is working but... I have no "keep_alive" configuration in my YAML. In logs (debug level) I see the following every few seconds:

`2023-08-23 14:46:52.668 DEBUG (MainThread) [custom_components.dual_smart_thermostat.climate] _async_control_climate_forced, time 2023-08-23 12:46:52.667375+00:00

2023-08-23 14:46:52.668 DEBUG (MainThread) [custom_components.dual_smart_thermostat.climate] _async_control_heat_cool

2023-08-23 14:46:52.669 INFO (MainThread) [custom_components.dual_smart_thermostat.climate] Keep-alive - Toggling on heater cooler switch.oficina_heater, switch.oficina_cooler`

Could it be related in some way to the new opening configuration and the new timing feature?

Thanks in advance for your help.

from ha-dual-smart-thermostat.