WEIRD things arre happening about iosender HOT 8 OPEN

Start with First Run Settings.

from iosender.

Start with First Run Settings.

have done this now i still have alarm 10 with an error 13 but i have not door limit or anything attached to the port

from iosender.

i ended up removing all errors but

y axis is the only one that moved by jogging

HOMING cause Z and X to move at the same time

so i did $rst=* and now im stuck again having ALARM10 popping up

and a pop up on the screen asking to shut down IOsender because Estop is still active

from iosender.

sorry another update

unlocked it again

jogging X in - dir does nothing

jogging Z in - does both Z and X

from iosender.

If it worked before rewiring and the firmware has not been changed then either the rewiring has errors (shorts?) or the controller has been damaged in some way?

from iosender.

Yeah I’m starting to think the controller has been damaged somehow

from iosender.

Well, it is odd that motion works in one direction but not in the other - is the step signal lost due to the direction signal shorting it? Or is the enable signal in the wrong state (enable and dir swapped)?

from iosender.

I will have to have a look tomorrow or later tonight I’m sure everything is in the same spot as it was in before. It’s just weird that it doesn’t job but moves when homing but does Z and X at the same time

from iosender.