VOX not enabled using menu about usdx HOT 3 CLOSED

Guido: I did build my QCX-SSB from a new QCX+ kit but I just followed the existing instructions [PCB Rev5 Assembly Manual CLICK HERE] by Manuel, DL2MAN (document revision 1.1), 23-May-2020 The QCX+ has essentially the same schematic and all the part IDs R1, D2, etc are the same as the original - seems only the layout is different. I just followed the above instructions and referred the QCX+ parts layout to find the location and made all the substitutions outlined in the above file. I did use the QCX+ instructions for building the LCD board. For the jumpers that Manuel shows adding at the end - with the new layout those can't be done exactly as shown. I wound up putting all the jumpers and the 2 resistors on the bottom side of the board so the top looks cleaner. I used 30AWG wire wrap wire and some heat shrink. I did also hot glue in 2 - 4 pin female headers in the area where the LPF is supposed to built, and used QRP-LAB's LPF kit which is on it's own little board so that I can swap out the LPF when changing bands. Hope this helps. Thanks for all you do. I am getting ready to install the most recent firmware. 73 Greg KD4VV