[QUESTION]: Remote Control about ytmd-streamdeck HOT 3 CLOSED

Hey! Small update:

1. I've just now noticed you're in the wrong repository lol :D you're in the StreamDeck Version, but this update also applies to you
2. V2 (StreamDeck) is very near to completion and the Loupedeck Version follows ASAP.
3. With the next update your issue should work as expected
4. Due to the fact that this is in the wrong repository, I'll gonna /close it here but I'll still double checking it in the Loupedeck Version, after the V2 migration is done.

from ytmd-streamdeck.

Hey and thank you for opening this issue.

The plugin should have the possibility to do this (but I haven't tested it, nor do I "officially" support it). The most important parts for this to work are:

1. PC 1/2 must can communicate with PC 2/1. Also they must be able to access the "Remote Control" page themselves (see screenshot)
2. Host has to be the same as "Ethernet" on the remote control page (see marked spot on screenshot)
3. Port must be right

This also probably means: You've to enable it in the firewall and port forwarding/routing in your router/modem (example: FritzBox)

from ytmd-streamdeck.

Hi thanks for the quick feedback so I could test it now.

I think that when Loupdeck starts it can't connect because maybe because in this time Loupdeck starts too fast.

What I did is change the IP address of the host on PC01 from 192.x.x.110 to 192.x.x.99 and then back to 192.x.x.110.

With this I could see 2 devices in the webpanel but unfortunately still not control them via loupdeck.

A restart of Loupdeck did not help either. Since now only 1 Device was shown to me, so I had to repeat the IP procedure.

The plugin still shows that no connection could be established, even after the IP test.

According to the website are two devices available but primarily it can only control 1 Loupdeck and that is what runs locally PC02!

I have then tried to press the PC01 "Next Track" in the hope that the connection exists it Loupdeck has not realized. Unfortunately, I get a crash from the Loupdeck software and stand again at the beginning.

from ytmd-streamdeck.