444a49 / minifindings Goto Github PK

Hey man, do you have a discord/messenger so we can talk?
I'm working on the MM root as well and now I'm working to exploit the memory.
My discord tag is: WPmeister#9853

Hey, thanks for your reserach.

I wonder which firmware you used, since the maximum downward speed parameter doesn't seem to work on .500, .400 and .300?

Other tested parameters like upward speed work fine.

Hello,
I would like to ask that what port of the RC is OK for telnet connection over usb-ethernet? The standard USB and the micro also? Thanks!

Hello my friend, I have one manic mini too and I'm living on restricted zone, so, I cannot open my window and start to fligh, because when the drone get the gps signal, it's show on the app the message attached here.

I have 90 seconds before return or the drone will be start to landing.

Do you have any way to block this? I just want to flight with my drone next to my house.

I'm developer too, so , I can do things in low level if you have some trick.

Thank you so much!!!

Hi,

is it possible to access RC controller's Android filesystem through adb ?
how ?

Just bought a Mini 2 and would love to be able to remove the NFZ restrictions. Thanks!

Hello friend.
I have an idea how to make semi-pernament FCC mode. However, since I have very little Linux knowledge, maybe you can help me.
I found by measuring the TX power and testing the RC that if I change the "country = ??" to "country = US" in the "/etc/amt/wifi.conf" file, RC always switches AC to FCC mode. Of course, if I connect the apk before turning on the engines, the apk will change FCC mode back to CE mode.
The solution would be to write the code :: "sed -i 's/country=../country=US/' /etc/amt/wifi.conf" somewhere in the code after the RC is booting.
This cause that each time the RC is switched on, it always switches to FCC mode. And if we connect the apk after starting the engines, the FCC mode does not change back to CE mode.

Note: Using the "disable_country=1" switch will permanently switch to FCC mode, but with a lower TX power than using "country = US" or fake gps.

Measured TX power (not totally exact) ::
CE mode ~ 2 dB (country = SK)
FCC mode ~ 18 dB (country = US)
disable_country=1 ~ 10 dB (country = ZZ)

Mavic Mini FCC, firmware:: .300, apk DJI fly version 1.1.2

Hello is it possible to remove the speed limiter of the drone?
It is currently set to 50km/h ish.

I cant seem to get the descend speed faster using the instructions.
Hover height etc works fine but the drone simply wont go down faster then 12km/h

Anything i am missing maybe?

Good afternoon, I ask for help. how to calibrate height on dji mini 2 or how you can link barometer readings to lower sensors. Is there a python command or calibration that solves this problem? Or a hidden setting?

Mavic mini 2 seems to have the same camera as the mini 1. Seems like there should be away to remove the limitations to allow 4k on mavic 2, perharps a way to foold the app into thinking that mini 1 is mini 2?

Do you think this is possible and if so, could you please tell me in which direction to look?

I tested two adapters, but none of them worked