abassign / g91-r1b_hd Goto Github PK

Unlocking the canopy and flipping switch (so the panel control, not the keyboard) to 'OPEN' opens the canopy. The switch however reverts to 'CLOSE' position by itself. This makes it impossible to close the canopy again using this switch.

Using the keyboard controls suggest this is a three way switch with a neutral position in the middle. Then there are two problems:

1. The animation needs to be adapted to show the switch in the neutral position, not in the 'CLOSE' position

2. The click sensitive area around the CLOSE label moves the switch towards the 'OPEN' position, instead of the 'CLOSE' position

There is an error within G91-Acro.xml. There is a tag beginning at line 65 that is never closed. Line 256 should contain the closing tag.

The following tags could be added to G91-R1B-common.xml

• fighter
• 1950s
• coldwar
• combat
• low-wing
• ifr
• retractable-gear
• tricycle
• jet
• single-engine

Within file G91-R1B_HD/Models/Parts/Canopy/Lateral_Panels_Left/Pitch_Yaw_Damper/sw_model_no_protection.xml

line 31 close tag is incorrect. It should be instead of

Hello there!
I downloaded your excellent project and tried to use it with FlightGear 2018.3.2 but it fails to start.
I always get this message from FG and then it quits.

FGPropertyValue::GetValue() The property systems/gauges/PHI/attitude/gyrocompass-magnetic-deg-var-linear-360 does not exist.

The digits of a transponder are octal numbers, each goes from 0..7. Transponder codes go from '0000' to '7777'
This transponder has decimal numbers, going from 0..9. This allows for impossible transponder codes.