I am wanting to use three NPA700 sensors on one I2C bus with an Arduino Uno R3 and I am hoping to get 200 samples a second from each sensor. I want to run two NPA700B001G and one NPA700B10WD. Currently when I run one NPA700B001G sensor I'm getting status bits of 11 in binary or "Internal Fault Exists" on a sensor I changed it's address to 0x32 or 50. On another NPA700B001G sensor with no changed address, I get status bits 10 or "Repeat Read". In each case, the pressure value looks correct. Is it okay to ignore the status bits? I notice in the code on this project doesn't look at them. Thanks.