A short description of the keyboard/project

A split column staggered ortholinear keyboard that utilize single RP2040 microcontroller. Has an analog joystick that act as a mouse with left and right click button using micro switch. Heavily inspired by scotto_split by Joe Scotto.

Included prebuilt firmware: split_fire_anz507.uf2 or you can compile using comand below.

• Keyboard Maintainer: Ahmad Anshori
• Hardware Supported:
  • Handwired
  • RP2040 microcontroller
• Hardware Availability (if you are around my country, just follow the link :)):
  • 1x Raspberry Pi Pico RP2040
  • 1x KY-023 ANALOG DUAL AXIS XY JOYSTICK MODULE
  • 2x Kailh Silent Mouse Micro Switch (Yellow - 4.3mm)
  • 38x Diode 1N4148
  • 36x Any MX switches AKKO CREAM BLUE V3 PRO
  • 36x Any keycaps Keycap XDA Profile
  • 30x Spacer Nylon Plastic 1.5cm
  • 30x Spacer Nylon Plastic 1.5cm and bolts
  • Jumper cables
  • 18 gauge copper wire
  • Shrink tube
  • 2x VGA Head male & female
  • USB C cable
  • 2x FULL RGB 8bit Ws2812 Ws2812b
  • CNC acrylic plate

Make example for this keyboard (after setting up your build environment) using qmk:

qmk compile -kb split_fire -km anz507

Flashing example for this keyboard:

 Hold reset button on RP2040 and plug in usb c cable
 Device will be detected like a USB flash drive on computer
 Copy and paste split_fire_anz507.uf2 to RP2040

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available