Repo for with home assistant blueprints

It’s a simple blueprint for ROBB SMARRT ZigBee Wall switch, that maps all the available actions for all 8 buttons. The available actions are:

• short press (each button)
• long press (each button)

This allows you to map any of the button (events) to any action you choose.

Same as 8 button wall switch but for the 4 button variant

Same as 8 button wall switch but for the 3 button variant

It’s a simple blueprint for ROBB SMARRT ZigBee Remote controller, that maps all the available actions for all 5 vertical buttons. The available actions are:

• short press (each button)
• long press (each button)

This allows you to map any of the button (events) to any action you choose.

Old name keeping for installed base

Repo with some ESPHome yaml examples i do use..

Control a dimmable LED with a single on/off-switch used with a wall-mounted mains-switch controlling a relay as input and a MOSFET controlling the LED. Switch off->on will fade the LED to its 100%, Switch on->off will fade the LED to its 0%. If the switch is switched again during fading the LED will remain on the current light level. With a short toggle, the light will dim to 0% or to the previous light level. (The yaml file contains a double implementation, so for 2 LED's with their own switch)

Open/close the garage door with HA, using a relay by-passing a push-button for manually opening. Feedback about the door position is done via an untra-sonic distance sensor mounted above the sliding door.