Currently, build is failing for MoteinoMEGA boards due to an out-of-date pin definition in platformio. See issue #199 in platform/atmelavr

To fix locally, go to ~/.platformio/packages/framework-arduino-avr/variants/moteinomega/pins_arduino.h

Add in this line at line #72:

#define digitalPinToInterrupt(p) ((p) == 10? 0: (p) == 11? 1: (p) == 2? 2: NOT_AN_INTERRUPT)

Uncomment the last block in platformio.ini and then build again.

KISSLoRaTNC is a work derived from code written by Sandeep Mistry and Mark Qvist

This code was developed using VSCode and Platformio.

KISSLoRaTNC is developed for the:

• Arduino Uno, using the HamShield: LoRa Edition
• Arduino Micro, using the Adafruit RFM96W LoRa Radio Breakout
• MoteinoMEGA-USB with the RFM96 Transceiver

The Config.h file contains the pinouts for the different Arduino-based boards. These pinouts are specific to the microcontroller board and LoRa device pairings in the list above. If you decide to use a different pairing, please adjust Config.h accordingly. Also, please remember that the power output should also be adjusted, as the RFM96W has a max Tx Power value of 20dBm. The HamShield: LoRa Edition 440MHz can be set to 30dBm (1 watt).

"Default" settings are:

• Frequency: 434.450 MHz
• Spreading Factor: 8
• Coding Rate: 7
• Signal Bandwidth: 125 kHz
• Tx Power: 20 (can be set to 30 for HamShield)
• Serial: 38400, 8N1

Basically, after checking the Config.h file for correctness, build and upload to your Arduino-based board.

Useful applications:

• Xastir (APRS)
• tncattach (Ethernet compatible kissattach replacement)
• BPQ32 (Amateur Radio BBS Application)
• APRSDroid (Android APRS Application)