chilipeppr / widget-autolevel Goto Github PK

Hi, Sir
Is there any guidance how add your widget to cncjs step by step?
Thanks

Hi everyone,
When i use auto level, z axis goes down more.. What do you think about that ? By the way probing is okay. it works

I've seen this issue in other forums, and I can reproduce it reliably, auto-level probing completes the first check and then stops, does not go onto the next step.

I have had it working successfully once or twice but seems to be very intermittent.

I'm able to use the Autolevel > Run > Run Test Probe 100% of the time and it always stops where I would expect it to.

Here's my actions

• Enable Autolevel widget
• Click Auto-fill, I can then see the grid on my board
  
• Click the [RUN] tab
• Click the Play button
  
• Click "Let's get probing"
• Z-axis goes up 0.5mm
• Z-axis comes down, stops at 0.014 which is what I expect
• The end, nothing happens after this

I see some debug output

Going into mm and abs coord mode
Generating probe steps.
Generated 143 probe locations.
Starting probes
Moving to {x:-0.475,y:-0.475}

All settings seem fine, I am not breaking out of the max minimum-Z

I'm within version requirements

[fb]  firmware build            440.20
[fv]  firmware version            0.97
[hp]  hardware platform           1.00
[hv]  hardware version            8.00
[id]  TinyG ID                    3X3566-KSL

The button appears to go into the 'pressed' state and does not return..