This repo contains a series of MCU control codes based on the CC2530 chip and finally developed an intelligent monitor system that combined the control of CC2530, Zigbee and User Interface with C++ QT Creater.

(本项目包含一系列基于CC2530芯片开发的单片机控制代码，并最终开发出一个完整的智能温湿度光照监控程序；)

Some implementation functions: control LCD, LED lights, control sensors, wireless node networking, wireless node time synchronization

一些实现功能：控制LCD,LED灯，控制传感器，无线节点组网，无线节点时间同步

TempHumiLightQT : A complete project to check and adjust the temperature, humity and light in a room.

TempHumiLightQT :完整的检查并调整室内温度，光照，湿度的程序

硬件(hardware)： 包含CC2530芯片，带LCD，LED的智能主板 (CC2530chips with LCD and LED) 温湿度及光电传感器SHT10 (sensor SHT10) CC-Debuger ： 烧录.hex文件给智能主板 (CC-Debuger to write the code to the board) PC一台 (A PC) DB线 (公母口) ： 连接智能主板和PC主机箱 (A DB Line) USB数据线若干 (Some USBs)

软件(software)： IAR Embedded Workbench8051 6.4 QT Creater Community 4.11.1 / 4.13.2

function-code realized some functions. Including:

• LEDControl: Light 6 LED in turn
• Interrupt: Test for interrupt
• Sensor: Control sensors
• SimpleRF: Simple RF communication
• RF: RF communication
• Spectrum: Analyze the Spectrum of each channel
• Net: A tree-topology wireless network
• Syn: Synchronization of wireless nodes

source-code : the TempHumiLightQT project