david-furminieux / nextcopterplus Goto Github PK

hi, i'm trying to connect the kk board with rs232 inteface, so i connect tx to 
miso, rx to pin 30, gnd to gnd and 5v to usb 5v, i see the com port but the gui 
didn't show any data.. what speed i must set on the rs232 port? 9600bps is 
defoult. thanks a lot

Allow switching camera stablization off but still allow output for flaps or 
bomb drop, etc.  Would need a screen to map the extra channels to the output 
M2-M4.

I've just wrote a quick Perl script which parses OA2 source-tree and creates a 
Makefile so the project can be compiled and programmed on linux using the 
standard avr toolchain and avrdude for programming. The script resides in 
nextcopterplus-read-only/OpenAero2 and creates a "linux" sub-directory where 
you only need to type "make". You may include this in the SVN if you find is 
useful.

What steps will reproduce the problem?

Connect Frsky receiver in cppm-mode to rudder input (input 4). 
Configuration:
RXsync: cppm
Ch.order: same result on both.
Receiver inputs-screen shows the correct stick-movements. 

What is the expected output? What do you see instead?

Throttle signal on M1. Instead I get Rudder on M1 (and also on M8).

What version of the product are you using? On what operating system?
1.0
1.1.1
1.2beta3
1.2beta8

Please provide any additional information below.

This is the first time I tried OpenAero2. Previously I used the kk2-mulitrotor 
firmware on this card. 
My transmitter is a Turnigy 9x with FrSky transmitter module and openTX 
firmware. My receiver is a D8R-II Plus, flashed with the XP 27ms cppm-firmware. 
As I wrote earlier on the receiver input screen, every thing looks alright. The 
throttlestick seems connected to the throttle channel as it should. It might be 
a setting I missed somewhere, but I have tried everything obvious. Channel 
mixing for channel 1 is the default 100% throttle.