euphy / polargraph Goto Github PK

Trace doesn't appear to be working, as WinVDIG and Quicktime need installs, and there are no listed instructions on how to get it up and running.

i made everything ok ,but after select the correct serial port,nothing happened.
how can i fix it.

This is interresting: When running the default map.txt queue it works fine. When I try to run a queue I saved myself, the script runs, it calculates savings, and it spits out all the commands. But the resulting file is empty. I first thought it was because it was places in my dropbox folder, and that the issue was with writing permissions, but the result is the same when running it in another folder.

Can you try to run the included txt, and see if you can figure out what it is?

I have tried two other vectors, with the same empty outout.

heiafotballlogo.txt

It would be nice to have the case cutting file in some other formats beside PDF - I wanted to cut it at the laser cutting service, but they only accept EPS or SVG.

I'm getting an error during compilation of "polargraph_server_a1.ino".
I have all required libraries installed.

What might be the reason?

Sir
I'm using ardiuno Uno cnc shield v3 A4988driver and nema17 stepper motor.
Software side.
Ardiuno 1.8.10
Polargraph​
Pic attached
Regards

Hello,
I have an unclear problem during a complex drawing, that seems to happen in different points of the drawing in a reproducible way. The drawing is going well but suddenly the gondola is moved to a low point of the board, outside the drawing range.
The last command in the queue seems to be a valid point in the drawing range, so it is not clear why the movement is wrong.
I am using polargraph controller last build with mac os binaries and an Arduino Uno with CNC Shield.

Print_error.txt
Btw the polargraph SW/HW is great, congratulations for creating it!
default.properties.txt