This repo is an Express server designed to run on an IoT device and handles the first-time setup required to get the device working connected to the user's home wifi network.

• since the device is not on the local wifi network when it is first turned on, the device broadcasts its own wifi access point and runs the server on that. The user then connects their phone or laptop to that wifi network and uses a web browser (not a native app!) to connect to the device at the URL 10.0.0.1 or <hostname>.local. The user can select then their home wifi network and enter the password on a web page and transfer it to the web server running on the device. At this point, the device can turn off its private network and connect to the internet using the credentials the user provided.

The code is Linux-specific, depends on systemd, and has so far only been tested on a Raspberry Pi 3. It requires hostapd and udhcpd to be installed and properly configured. Here are the steps I followed to configure and run this server.

First, clone this repo and download its dependencies from npm:

$ git clone [email protected]:davidflanagan/wifi-setup.git
$ cd wifi-setup
$ npm install

Install software we need to host an access point, but make sure it does not run by default each time we boot. For Raspberry Pi, we need to do:

$ sudo apt-get install hostapd
$ sudo apt-get install udhcpd
$ sudo systemctl disable hostapd
$ sudo systemctl disable udhcpd

Next, configure the software:

• Edit /etc/default/hostapd to add the line:

DAEMON_CONF="/etc/hostapd/hostapd.conf"

• Copy config/hostapd.conf to /etc/hostapd/hostapd.conf. This config file defines the access point name "Wifi Setup". Edit it if you want to use a more descriptive name for your device.

• Edit the file /etc/default/udhcpd and comment out the line:

DHCPD_ENABLED="no"

• Copy config/udhcpd.conf to /etc/udhcp.conf.

Once the wifi-setup server has connected to wifi, it will exit. But if you want, it can run a command to make your device start doing whatever it is your device does. If you want to use this feature, edit platforms/default.js to define the nextStageCommand property.

If you have a keyboard and monitor hooked up to your device, or have a serial connection to the device, then you can try out the server at this point:

sudo node index.js

If you want to run the server on a device that has no network connection and no keyboard or monitor, you probably want to set it up to run automatically when the device boots up. To do this, copy config/wifi-setup.service to /lib/systemd/system, edit it to set the correct paths for node and for the server code, and then enable the service with systemd:

$ sudo cp config/wifi-setup.service /lib/systemd/system
$ sudo vi /lib/systemd/system/wifi-setup.service # edit paths as needed
$ sudo systemctl enable wifi-setup

At this point, the server will run each time you reboot. If you want to run it manually without rebooting, do this:

$ sudo systemctl start wifi-setup

Any output from the server is sent to the systemd journal, and you can review it with:

$ sudo journalctl -u wifi-setup

Add the -b option to the line above if you just want to view output from the current boot. Add -f if you want to watch the output live as you interact with the server.

If you want these journals to persist across reboots (you probably do) then ensure that the /var/log/journal/ directory exists:

$ sudo mkdir /var/log/journal