groupgets / c12666ma Goto Github PK

I'm trying to decide if I should buy the breakout board. Which OpAmp was used?

where can I download a processing plot software to use with this code?

Hi,

The Arduino example you have (arduino_csv_example.ino) seem to have a few mistakes.

Line 76: int numIntegrationBlocks = (intTime * 1000) / blockTime;
Here the numIntegrationBlocks will overflow as on Uno it will not fit in 15 bit signed integer and the following loop never executes

Line 49: int read_time = 35; // Amount of time that the analogRead() procedure takes (in microseconds)
The comment at line 130 is actually more correct - on Uno analogRead() will take 111 microseconds (according to http://meettechniek.info/embedded/arduino-analog.html). In any case what the read_time is set to seems to be quite a way off.

Could you please correct them since the project is shared publically?

Can I use your code with this pinouts in this picture below? I tried this pinouts with your code and the data from arduino UNO's serial monitor appear 0,0,0,...,0,... I don't know why? It didn't respond to the light too.

ref: https://hackaday.io/project/4141/gallery#e71fc181a4271886a0c320dc47244037

Hi,

Not sure what I'm doing wrong but when I copied across the code to Arduino it said there were no problems, then when run (and viewed in Serial Monitor) it gave me a few numbers then just hieroglyphics:

(...),94,93,93,92,91,91,89,88,87,86,86,86,86,86,87,88,88,89,88,88,89,88,88,88,87,88,87,87,87,85,85,85,84,84,84,84,84,83,83,84,84,84,
)gž’-³µ²q282�!¢!"p²0‚2a¢p¢0á²ñ²p�œ'“!�ð�Z!(q¢pPH� �R)�!�¢"x1�’%3);131���þË”äœí”¤’Ã�½’-q¢0#Y‹še²pPI#�%=ð#���m"Q/“��¢&�#��%’µ€9¢� %�a³5³9��’139�S�’k8¼²<�š%“¥�Ph† †�q2q²p2�#���¢9ð"��<p'�#—��-=p����)�!�!’%�Ô��
³1�–��;1��Á†’º´²±���uX
(...)

What can I do to get these results into a usable format?

Thanks