Some Questions about tiny-m HOT 10 CLOSED

Thanks for your amazing work! Bom is when will be available?

Hi, I am working on the BOM. So, maybe end of this week.

from tiny-m.

Hello ,

to your first question.

At the beginning this printer was planned as a small version of a Voron 1.6 with linear rails. So the extrusion lenght was get from the calculator at vorondesign.com for a size of 120x120x130. The goal was not to get a specific build size, but a fixed outside dimension for the frame of 300x300x300mm. Later the V0 was released and i desided to switch to the V0 design. The good point was , that i recognized that with the V0 design a build size o 150x150x150 was possible with extrusions i already had.

to your second question.

I'm working on a BOM at the moment. Onshape has this feature included, some parts are still missing and some parts(like printed part) are not excluded from the BOM in Onshape. Later i will put a excel sheet here.

This is my first project of this kind. Maybe something will be missing, is not well documented, or just messy. I apologize for that.

best regards

GSL12

from tiny-m.

Hi guys,

sorry that it took a little longer.

I have attached the BOM to this post, but it is not final yet. The links to the sources (local source, AliExpress, etc.) are still missing. I'll upload an updated version on Sunday. When designing, I stuck to the original BOM from the Voron V0.

If you want any changes, just let me know.
DRAFT - BOM - Tiny M.xlsx

@gsl12
@hhammarstrand
@BTopbas

from tiny-m.

Hi,

thank you for the quick and comprehensive answer to the questions.

If you need support, just let me know. Maybe I can help.

I will definitely build your variant of the Voron and look forward to your bom.

Do you use discord?

Best regards from Germany,

cookieSN

from tiny-m.

Yes i use discord. Username same as here.

from tiny-m.

Thanks for your amazing work! Bom is when will be available?

from tiny-m.

Another question related to the BOM; can the Tiny-M be built from 2020 V-slot?

from tiny-m.

@cookieSN Thank you!

@gsl12 Do you know if it's possible to build the T-M with v-slot extrusions? I have some left from my old printer and it would be nice to be able to use them

from tiny-m.

@hhammarstrand
Because of the MGN9 the Tiny-M has the same restrictions as every other Voron. V-Slot was not recommended while the Nut is to big. MGN9 is 9mm width and Mitsumi Profile's nut is 6mm. The nut of the profiles i use is 5mm.
I'm not sure but the widthest point for the V-slot is 9.2mm, so you can't get the right position for the MGN9 rails.

from tiny-m.

@gsl12 Thank you for the information. I will have to find another use for the v-slot then. The plan is to build a Tiny-M when I'm done with my Switchwire.

from tiny-m.