CB28M1B-1 - up/down switches not working about loctekmotion_iot HOT 5 OPEN

Ah sorry, those up and down switches were set to internal. I remove that, now its working

from loctekmotion_iot.

You should see a cover with up/down buttons, hence why you don't see the switches. On Discord I shared a newer config with button support as well, however I didn't had time yet to add it to the repo.

from loctekmotion_iot.

Im not really into Discord. But I will check it. Or are you able to post it here?

from loctekmotion_iot.

https://gist.github.com/iMicknl/2890d738ede31947b81fb33b8951c242

from loctekmotion_iot.

I have a standing desk with CB28M1S-1 controller, the up button stopped working. It required a reset. The reset was simple, press the lowering button until the desk hits rock bottom, hold it until the motor stops then try’s to raise slightly automatically. The reset is now complete and the up button should work again.

from loctekmotion_iot.