A plugin that uses SNMP to get error codes from a Siemens Scalance X300 or X400 switch. The plugin outputs the fault in a human readable form, as long as there are not several faults.

The script reads the OID snX300X400FaultValue and outputs the fault.

• Power error
• Linkdown error
• Power error and Linkdown error
• Internal error
• Standby error
• rm error
• observer error
• non-recoverable ring error
• c-plug error
• pnio error
• module error
• loopd error
• Standby observer error

If there are more than one fault, the script will output "More than one error on device!".

Add the script as a check in any Nagios compatible product with proper variables.

The script expects either two variables for SNMPv2c or six variables for SNMPv3.

The variables are documented in the script.

• 1.1 2015-08-04 Cleaned up some minor ambiguities.
• 1.0 2014-10-27 Initial release. Tested with CentOS, Op5 and Scalance X300.

Licensed under the Apache License Version 2.0

Written by [email protected]

http://www.joubbi.se/monitoring.html