Shell script to install a GIN Coin Masternode on a Linux server running Ubuntu 16.04. Use it on your own risk. This script will install GIN 1.3.0.0

wget -N https://raw.githubusercontent.com/zoldur/GinCoin/master/gin_install.sh
bash gin_install.sh

After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps for Windows Wallet

1. Open the Gin Coin Desktop Wallet.
2. Go to RECEIVE and create a New Address: MN1
3. Send 1000 GIN to MN1.
4. Wait for 15 confirmations.
5. Go to Tools -> "Debug console - Console"
6. Type the following command: masternode outputs
7. Go to ** Tools -> "Open Masternode Configuration File"
8. Add the following entry:

Alias Address Privkey TxHash Output_index

• Alias: MN1
• Address: VPS_IP:PORT
• Privkey: Masternode Private Key
• TxHash: First value from Step 6
• Output index: Second value from Step 6

9. Save and close the file.
10. Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
11. Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is unlocked.
12. Open Debug Console and type:

startmasternode "alias" "mn1" "mn1"

If you are running an old Gin version, simply running the installer will update you to the latest version.

gincoin-cli mnsync status
gincoin-cli getinfo
gincoin-cli masternode status

Also, if you want to check/start/stop Gincoin , run one of the following commands as root:

Ubuntu 16.04:

systemctl status Gincoin #To check the service is running.
systemctl start Gincoin #To start Gincoin service.
systemctl stop Gincoin #To stop Gincoin service.
systemctl is-enabled Gincoin #To check whetether Gincoin service is enabled on boot or not.

Any donation is highly appreciated.

GIN: GbPXbAnBHfjR63uyvMsV2dK6ZhxGoSxyvv
BTC: 3MQLEcHXVvxpmwbB811qiC1c6g21ZKa7Jh
ETH: 0x39d10fe57611c564abc255ffd7e984dc97e9bd6d
LTC: LNZpK4rCd1JVSB3rGKTAnTkudV9So9zexB