Fast Arduino library for SPI displays Ili9341 and ST7735

• Low code usage (configurable in config.h to remove unneeded code parts)
  • Minimum sketch size for Ili9341: 2100 bytes
  • Minimum sketch size for ST7735: 2124 bytes
• Low memory usage
• hand optimized SPI code for maximum speed
• Fonts:
  • Font compression to save flash space (4bit packed and RLE encoding)
  • 0, 90, 180, 270 degree rotating (only 0 and 180 bit for RLE fonts)
  • antialiased fonts
  • auto cropping and expanding
  • align left and right or center
• Ability to drive multiple displays (same type and different types): each additional display only uses one extra pin
• example sketches to show performance and features
• hardware scrolling window support for Ili9341

• Has been tested with ATMega328P @ 16 MHz
• If the chip is running at a different frequency, disable FASTSPI

Display         Arduino
==================================================================================================
SDO/MISO        12 - fixed
LED             +3.3V or PWM (Attention! Needs more than the max 40mA an Arduino pin can deliver!)
SCK             13 - fixed
SDI/MOSI        11 - fixed
D/C             9 - fourth parameter
RESET           2 - third parameter
CS              10 - second parameter
GND             GND
VCC             +3.3V

Display         Arduino
=====================================
GND             GND
VCC             +3.3V
RESET           2 - third parameter
AO              9 - fourth parameter
SDA             11 - fixed
SCK             13 - fixed
CS              10 - second parameter
LED+            +3.3V or PWM
LED-            GND

#define FASTSPI

Pro:

• Fast

Contra:

• Uses a little bit more code space (can be as high as 1kb in big projects)
• Only works with 16MHz clock
• Only tested on ATMega328p

#define MODEL_ST7735
#define MODEL_ILI9341

Comment out all models you don't use

#define TEXT_ROTATE_0
#define TEXT_ROTATE_90
#define TEXT_ROTATE_180
#define TEXT_ROTATE_270
#define TEXT_ROTATE_0_RLE
#define TEXT_ROTATE_180_RLE

Comment out all rotations you don't need

Fonts are generated with generateFont.py (needs cairo and pango for Python).

Usage:

generateFont.py [-h] [-s SIZE] [-a {packed4,rle,unpacked}]
                [-f FIRSTCHAR] [-l LASTCHAR] [-e EXTRACHARS]
                fontname

Example:

python generateFont.py arlrdbd.ttf -s 12 -a packed4 -e äöüÄÖÜß > font1.h

Will generate a font1.h file with a 12 point font and chars 33-127 and extra chars äöüÄÖÜß (these will be mapped 128..134)

Two pixels are compressed into one byte, usually the best compression for smaller fonts (up to 16-18 points size).

Rotation can be performed 0, 90, 180, 270 degrees

A simple RLE compression is applied. Fonts need to be bigger (18-... points) to be effective

Rotation can only be performed 0 and 180 degrees

These can be generated, but the library cannot use them.