- Get control layer setup from Home Assistant
- Get control layer on to Raspberry Pi
- Create in/out interface for relay control
- Create in/out interface for pi control (slackbot?)
- Connect components
- Drink Coffee
- Champagne.
- AUTOMATION AROUND ENV VARS
- Replace Nginx on Pi with small Go Web Server
- Trim all fat off of Pi (remove Ruby, camera software, etc.)
- Determine if docker/swarm can be used
Set up port forwardingAdd DMZ to routerSetup Dynamic DNS for multiple sub-labelsAdd/Configure/Daemonize ddclient on Pi- Deploy Home Assistant to Droplet
- Explore Docker and automation for above also
- Determine location for state machine and polling
- Champagne
Welcome Message from Home Assistant:
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Hello, and welcome to Home Assistant!
We'll hope that we can make all your dreams come true.
Here are some resources to get started:
- Configuring Home Assistant:
https://home-assistant.io/getting-started/configuration/
- Available components:
https://home-assistant.io/components/
- Troubleshooting your configuration:
https://home-assistant.io/getting-started/troubleshooting-configuration/
- Getting help:
https://home-assistant.io/help/
This message is generated by the introduction component. You can
disable it in configuration.yaml.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Open UI interface on default port 8123
default config at ~/.homeassistant
(Mac OSX):
hass --open-ui
Use a different config file:
hass --open-ui --config path/to/config