Grbl 1.1e fork for the Carvey machine

You can compile and flash a Carvey using the Arduino IDE. You just have to put this repo into the libraries folder (by default ~/Documents/Arduino/libraries) or symlink this directory there. It is recommended that you remove previous versions of the gCarvin library before moving it into the libraries folder to avoid confusion.

Then re-open the Arduino IDE and look under Examples -> gCarvin -> grblUpload. That sketch will compile and upload the firmware.

Make sure to have the "Board" type set as "Arduino Mega 2560".

The gCarvin firmware is a specialization of grbl intended for use on the Carvey 3D carving machine from Inventables. gCarvin supports the following features:

• grbl 1.1e base features
• Carvey Gen 2 Hardware Support
• Variable Spindle Speed
• Spindle Over-Current Detection
• Door Open Interlock
• Button/Status LED
• Spindle Active LED