MinimOSD made smaller with better pinout and USB.
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.

After assembly, review the Firmware notes for loading software.

There are four jumpers that are useful for configuration.

Two are sets of three pads labeled 12-5. The one closest to the IN pad sets the camera voltage. Shorting the two pads on the 12 side sends 12V to the camera, and the two closest to the 5 side sends 5V to the camera. The one nearest the OUT pad is the same for the VTX.

On the same side, there's an GND jumper which configures a common ground for the OSD itself and the video.

On the other side, there's one labeled +V which jumps the 5V input pins so you can have a single 5V input that is used for both outputs and operating the OSD itself.

• D1, D2, D3 - 3x 0603 LED
• D5 - 0805 Schottky
• IC4 - MAX7456EUI+
• U1 - Atmega 328P AU
• U2 - 0603 1k Resistor Array OR digikey
• U9 - CP2102
• C1, C2, C3, C4, C5, C6, C17, C19 - 0603 0.1μF
• R1, R14 - 0603 10kΩ
• Y1 - 16MHz resonator
• R2, R3 - 0603 75Ω
• C18 - 1μF cap
• Q1 - 27MHz resonator OR digikey
• C7, C8 - 0603 47μF tantalum cap
• J1 - USB micro B or digikey