matteomanzoni / rehauneasmart2.0_gateway Goto Github PK

My System seems a little different from yours. I have 3 panels (on in each floor), the main one is the one in the pictures.
I think that modes is already used to "talk" with other panels.

It seems to be one connection still available on the left. Is that one that should be used ?

Thanks

Hi Matteo,
thx for your great work! I bought the Hardware but can you make a photo pls für cabling Waveshare to sys bus? I will be nice so I can start tomorrow. Thx

The temperatures in Homeassistant and also at Rehau itself are regularly set back to 7 degrees. What could be the reason? I'm desperate. I set the temperature (whether via the thermostat or home assistant) to 20 degrees and after a certain time it is back to 7 degrees

Finally I installed the system, half year later :)
Using Waveshare POE and running as HA add-on.

My Rehau setup is with 3 floors, each one with its own rehau panel (valves controller), the main panel is on basement:
-1 (basement) is 1 heating area
0 (main floor) is 2 heating areas
1 (bedrooms) is 3 heating areas

My first difficulty is to properly configure the Integration in HA, I need to input the areas names (comma separated), but with which order?

I tried one random order, to after try to identify the correct one, and set it up again with the correct order.

But after doing this first setup, only 3 areas are returning information (Humidity), after putting the preset in Normal, only then I was able to adjust temp. thermostat.

But the other 3 areas, never had any information. After playing with thermostat, I was able to identify the 3 missing areas.
They are the areas from bedroom (1st floor).

Have you any idea of what maybe the issue here?

Can I debug it some way?

Thanks!