A parametrized 3D photo Frame in OpenSCAD. Easily adjust the frame size, thickness, depth, and photo inset.

See it on Printables.com

• nominal_dimensions sets the photo size.
• front_depth sets the thickness of the frame in front of the photo. A high value here will create a shadow box effect.
• back_depth makes the photo frame thick or thin.

Your default printer settings are probably fine. Here's what I used:

• PLA
• 0.2mm layer height
• 10% infill

• Print face down without supports.
• Can be printed face up with suppports on the inner edge (e.g. if you want to put text on the front). Avoid using supports in the two slots for the back and in the hanger hole.

• Just print it. No supports needed, and infill doesn't matter since it's so thin.

Wide Frame

Deep Frame

Shadow Box