An Arduino library for sending and receiving data using ISO 15765-2 or ISO-TP (Transport Protocol) over CAN-Bus protocol. Support segmented communication point-to-point between CAN nodes via two defined CAN Identifiers. Base on 11 bit CAN identifier scheme address.

     _____________
    |             |
    |  CanIsoTp   |
    |(ISO 15765-2)|
    |_____________|
    |             |
    |    CAN      |
    |(ISO 11898-1)|
    |_____________|
           |
 |--------------------| CAN bus

The CAN-ISO-TP soport in transmision and reception:

• Single Frames (SF).
• First Frame (FF).
• Flow Control Frame (FC), Block Size (BS) and mimimum Separation Time (STmin).
• Consecutive Frames.
• Timeout Session.
• Timeout FlowControl.
• Timeout WFTmax (Maximum limit number of CANTP_FC_WAIT).

This proyect use the library arduino-CAN from Adafruit and it is compatible with the following hardware:

• Adafruit Feather M4 CAN Express with ATSAME51
• SAM E5x microcontrollers
• Microchip MCP2515 based boards/shields
• Arduino MKR CAN shield
• Espressif ESP32's built-in SJA1000 compatible CAN controller with an external 3.3V CAN transceiver

This protocol has been developed and tested wiht:

• Adafruit Feather M4 CAN Express

cd ~/ProjectFolder
git clone https://github.com/MLeganes/arduino-CAN-ISO-TP.git

Check the folder /example.

This library is licensed under the MIT Licence.