mortalisk / geosketch Goto Github PK

Once a layer's outline has been drawn, the layers surface should be calculated by interpolating and then shown.

When drawing a new layer, it should be sufficinet to draw on one side of the cube, and the rest of the surface should be suggested. There was some code for this earlier, but it interfered with oversketching, so it must be reimplemented.

Make it possible to select layers in a combo box

Improve layer creation, so that it interpolates nicely the drawn splines

Currently, over-sketching only works in one direction while drawing. The intended behavior is to enable right to left and left to right over-sketching during drawing.

Undo should work also for layers, such that it is possible to undo each layer creation, and jump back to the state you had before, with splines ready for editing again, and other layers intact

Sometimes, the suggestion on the other side of the cube is not completed. This must be fixed

If oversketched spline is actually following the spline but still has the first and last points in opposite direction of the spiines first and last points, then it will traverse in wrong direction and add additional points in the middle.

There should be a way to undo the last action.

Se igjennom paper http://dl.acm.org/citation.cfm?id=1507155

Makes it possible to edit a layer's splines.

Currently drawing on a face of the cube where there is a spline, will add the drawn points to the spline's end in stead of modifying it. Also it will auto complete it, which should not be done for existing spilnes.

We want to connect the beginning and end of the newly drawn curve to the nearest points of the spline, and erase the old points in between them.