The official release of the Voron Zero 3D printer. You can find the BOM in the configurator located at the Voron Design website.
The current revision is V0.2r1
- Compact and portable
- 120x120x120 build volume
- CoreXY
- Low mass direct drive extruder
- Enclosed chamber
- 24v DC bed
- Klipper firmware
- Filament runout sensor
Skirts
- We fixed the issue where 34mm Z motors didnt fit in the machine with the bottom panel installed, this involved increasing the height of the skirts/feet by 2mm
- We added a simple filament runout sensor to the rear right foot
Toolhead
- Mini Stealthburner direct drive and bowden cowling part cooling ducts improved
- an issue with the guidler being able to pivot in an undesired direction was addressed by tightening the bolt holes to reduce play
- RIDGA support for the bearings that come stock with the ridga kit has been added
Tophat
- cam locks for the tophat were changed to a simple hex key design
Z Endstop
- z endstop mount was beefed up to improve ridgidity
BOM Changes the BOM increased by the following items
- 2x m2x10 self tapping screw
- 1x MR85 bearing
- 1x Microswitch
- 1x ECAS04 Bowden Collet
A majority of the printed parts have changed. The configurator will give you an idea of parts needed if you are upgrading from V0.1.
Toolhead
- New design: Mini Stealthburner
- Direct Drive Extruder with BMG gears and 20mm thick pancake motor with 10 tooth spur gear
- Improved part cooling ducts (fans are same as V0.1)
- Supports Revo VORON, Dragon, Dragonfly BMO, DropEffect XG, Creality Spider Pro
Drive units
- Motor screw count reduction
- Endstop removed for sensorless homing
Frame
- No changes
Tophat
- All panels have changed
- All side panels are identical
- Extrusion based tophat
- Hinged design
- Cam locks to secure tophat in place
Panels/Clips
- All panels are 3mm
- Deck panel changed, new panel is not required
- Split rear panel
X/Y Joints
- Tops became 1mm smaller to accommodate MiniSB
- Endstop block removed for sensorless homing
Bed Assembly
- Printed parts changed, bed position moved 3mm to the rear
Feet/Skirts
- Trident skirt community mod folded into official release
Front Idlers
- Cam locks added
See https://github.com/VoronDesign/Voron-0/releases/tag/V0.1
See https://github.com/VoronDesign/Voron-0/releases/tag/V0.0r1
See https://github.com/VoronDesign/Voron-0/releases/tag/V0.0