"Andy Edition" pylog is not working with US3000-C
It works only with US3000-B (I have two and it reads both packs of -B type).

But it does not read one US3000-C.
And it does not read US3000-C with two additional US3000-B as well.
(As per pylontech, US3000-C shall always be master if there are US3000-B in the same system / on the same bus).

RS232 console and connection is verified, the US3000-C shows the pylon> prompt etc. and it works with serial terminal on RPi.
(of course the initial speed switch command needs to be sent, this is the same as for US3000-B).

Unfortunately, all new pylontech batteries are now sold as the updated US3000-C.

Could you update pylog ? thank you
Small donation will come afterwards.

Do you need some more info ? command listings ? tell me I'll provide

Hi! the source code is missing from the git. Can you check?

Is it possible to extend pylog
to read the recommended charging currect for the whole battery pack assembly
(e.g. having multiple parallel US3000-B/C batteries, charged at once as a whole pack),
and to provide the value to MQTT topic ?

That would be greatly appreciated (small donation afterwards).

Hello,

sorry for the dumb question but i've found literaly nothing on how to connect the US2000 to the Raspberry. My US2000 is connected to the pip inverter with one "special" communication-wire to the RS232 at the pylon.
Some stats are broadcasted by solpiplog itself, but it would be cool to get more data :).
If i'm connecting via USB to RS232 adapter and the cable from my inverter (Sub-D to RJ45?) and plug it in to CAN, pylog seems to connect to something but doesn't deliver data...

Any ideas?
Thanks for your time to code such a great program. I really appreciate it!