parrot-opensource / mambo-opensource Goto Github PK

Does anyone tell me how to configure Mambo can answer for 'hcitool scan'?
It only responses for 'hcitool lescan'.

I am trying to compile the code and then upload the same on Mambo drone. But I am not sure about the workflow to do this. I can a lot of folders containing i2c and gpio code. But I am not sure about the compiler to use to compile.

I need help with the following:

1. Compile the code in Git
2. Load the compiler output to mambo

Any advice/suggestion is appreciated

I am trying to connect the Parrot Mambo drone to the Debian Linux operating system. I have powered on the drone with the battery connected.
I run the following command on Terminal to scan for all bluetooth devices
sudo hcitool scan

But the scan is not able to detect the drone.

I tried doing the same in Windows 10. I am using ABE Bluetooth Dongle for this purpose. Even there it is not able to detect the drone.

Any idea what needs to be done so that the drone turns up on scan on both Linux and Windows?

P.S. - I tried the same on Parrot Rolling Spider Drone. And I could see the drone being detected on both Linux and Windows 10.

i wanna know how to use this source