robot-challenge's Introduction

robot-challenge

Description

The application is a simulation of a toy robot moving on a square tabletop,of dimensions 5 units x 5 units.
There are no other obstructions on the table surface.
Application can read in commands of the following form:
```
PLACE X,Y,F
MOVE
LEFT
RIGHT
REPORT
```
PLACE will put the toy robot on the table in position X,Y and facing NORTH, SOUTH, EAST or WEST.
The origin (0,0) can be considered to be the SOUTH WEST most corner.
The first valid command to the robot is a PLACE command, after that, any sequence of commands may be issued, in any order, including another PLACE command. The application should discard all commands in the sequence until a valid PLACE command has been executed.
MOVE will move the toy robot one unit forward in the direction it is currently facing.
LEFT and RIGHT will rotate the robot 90 degrees in the specified direction without changing the position of the robot.
REPORT will announce the X,Y and F of the robot. This can be in any form, but standard output is sufficient.
A robot that is not on the table can choose the ignore the MOVE, LEFT, RIGHT and REPORT commands.
Build and Play

JDK 1.8 required
Build and Play (Mac or Linux)

 $ cd {PROJECT_DIR}
 $ ./mvnw clean install
  $ java -jar target/RobotChallenge-1.0-SNAPSHOT.jar
  
  Welcome to ToyRobotSimulator, Lets play.
  Valid command to operate Robot are : 
  PLACE X,Y,F
  MOVE
  LEFT
  RIGHT
  REPORT

Recommend Projects